Ockam_the_System

Note: Very limited availability, products are shown for unit ID, all units are out of warranty

All Ockam units are shown for Product ID
NO new units available, there may be some used units available without waranty

A revolutionary new family of components named Tryad is now available. The Tryad system is composed of two major parts – the T1 CPU, redefining the term “CPU” within an instrument system and T2 Multiplex Wind/Boatspeed/NMEA input Interface , optional T3 e/Series interface (all formats) can be added to enhance the system's features.

Unisyn is a new release of the Standard Ockam System ( software rev A16.3) that supports three additional new interface types. The software continues to support all standard interfaces, new features will be activated when the new interface/sensors are installed. The changes described are relative to standard CPU software A14.4.

Interface modules for Unisyn and Tryad Systems

Tryad T2

Gyro Interface

Depth interface

Heading/Compass

066 Load Cell Interface

067 LoadCell Amplifier Interface

Barometer/Temperature

Mast Rotation

360 Analog Driver

Rudder

Engine Monitoring

MODEL 062 TRIM INTERFACE Trim

The Trim interface provides the Ockam System with trim (or pitch) readout.

MODEL 055 ANALOG OUTPUT MODULE

The MODEL 055 Analog Module supplies a voltage output analog of several display functions: Boatspeed, Wind, Heading, Heel, VMG, Depth and Rudder. Each is selected by standard display cards. The output is primarily used to drive strip chart recorders to provide hard copy for analysis. Plotting True Wind Direction and Speed can be used to predict wind shifts. Boatspeed, True Wind Angle and Rudder Angle could be used for tacking analysis.

MODEL 080 TELEMETRY SYSTEM

The Model 080 Telemetry System is designed to provide complete remote readout and logging functions for analysis and crew training. The system consists of a radio link between the Ockam system and a tender or shore base, sending the complete display data stream. It allows repeater displays, Stripcharts and data recording at the remote location. The link is one-way, from sailboat to tender. The Ockam instrument system consists of modules connected together by a single coaxial cable. The capability and cost of the system is determined by the type and number of modules. The modules consist of a central processor unit (CPU), output modules and input modules. You design your instrument system to fit your needs and budget. You don't have to buy more functionality than you need; you don't have to be satisfied with less either. The same modularity that allows you to put together simpler and less costly instruments, also permits design of complex and more expensive systems. You decide how fancy your instruments will be, not us.

Ockam Tryad T1 manual The complete Tryad T1 (operational and technical) manual in PDF format.